Skip to main content
NetApp Knowledge Base

ONTAP FlexArray WAFL hung after large increase in workload

Views:
362
Visibility:
Public
Votes:
0
Category:
v-series-flexarray
Specialty:
core
Last Updated:

Applies to

  • ONTAP 9.x
  • E-Series

Issue

  • WAFL Panic and node reboot
  • E-Series reports fibre channel errors 
  • Extreme performance degradation
    • Very high latency or "not available" for VOL/ LUN's reported
  • SCSI transport error against one port "Disk device 0z.1L00"
  • Node experienced a long consistency point (CP)
Example EMS Messages :
WAFL hung for <node>. in SK process wafl_exempt07 on release 9.6P5
ERROR  scsi.cmd.transportErrorEMSOnly: Disk device : Transport error during execution of command: HA status
wafl.cp.toolong: Aggregate xyz experienced a long CP
mlm.non.optimized.TPusage: Detected non-optimized usage of a array's target port
cf.multidisk.fatalProblem:info]: Node encountered a multidisk error or other fatal error while waiting to be taken over
"Host-side: controller in slot B, port <port>: Fiber channel link errors - threshold exceeded"

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

Scan to view the article on your device