Skip to main content
NetApp Knowledge Base

How to perform a cluster port loopback test for 2-node switchless clusters

Views:
6,152
Visibility:
Public
Votes:
3
Category:
fas-systems
Specialty:
hw
Last Updated:

Applies to

  • FAS2520
  • FAS2552/2554 
  • FAS/AFF 8020/8040/8060/8080
  • FAS2620         
  • FAS2650/AFF-A200
  • FAS2720
  • FAS2750/AFF-A220
  • FAS8200/AFF-A300
  • FAS8300/AFF-A400
  • 2-node Switchless Cluster (TNSC)

Description

This procedure is used to determine which motherboard is at fault for a 2-node switchless cluster that uses the on-board e0a/e0b ports when one or both of the cluster ports are flapping. For the purposes of the examples, the nodes will be Node_01 and Node_02.

Note that for nodes that do not use e0a/e0b for their cluster ports, the following procedure will need to be modified accordingly to refer to the correct in-use cluster ports on the respective nodes and available test ports as shown in the provided table.

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.