Coming soon...New Support-Specific categorization of Knowledge Articles in the NetApp Knowledge Base site to improve navigation, searchability and your self-service journey.

Home
Advice and Troubleshooting
Data Storage Systems
FAS Systems
EMS reports "cmds.sysconf.logErr:notice" after upgrading ONTAP to 9.3

EMS reports "cmds.sysconf.logErr:notice" after upgrading ONTAP to 9.3

Last updated
Save as PDF
Share
1. Share
2. Tweet
3. Share

Views:: 93

Visibility:: Public

Votes:: 0

Category:: ontap-9

Specialty:: core

Last Updated:

Applies to

ONTAP 9.3

Issue

EMS reports "cmds.sysconf.logErr:notice" after upgrading ONTAP to 9.3P21.

Example:

[Node01: sysconfig_periodic_checker: cmds.sysconf.logErr:notice]: sysconfig: slot 1: Number of the Broadcom LPE16004; Quad-Port 16Gb card (PN X1145A) exceeds supported maximum (1). sysconfig: slot 2: Number of the Broadcom LPE16004; Quad-Port 16Gb card (PN X1145A) exceeds supported maximum (1). .

X1133A-R6 HBA cards are installed, but ONTAP instead displays a message about an X1145A HBA card in the output of the sysconfig -ac command.

Before:

sysconfig: slot 1 OK: X1133A: Broadcom LPe16004 rev. A0

sysconfig: slot 2 OK: X1133A: Broadcom LPe16004 rev. A0

After upgrading ONTAP to 9.3:

sysconfig: slot 1: Number of the Broadcom LPE16004; Quad-Port 16Gb card (PN X1145A) exceeds supported maximum (1).

sysconfig: slot 2: Number of the Broadcom LPE16004; Quad-Port 16Gb card (PN X1145A) exceeds supported maximum (1).