Skip to main content
NetApp Knowledge Base

DegradedOnlinePort_Alert warning observed on the storage

Views:
694
Visibility:
Public
Votes:
0
Category:
fas-systems
Specialty:
hw
Last Updated:

Applies to

  • Fabric Attached Storage (FAS) systems
  • All Flash FAS (AFF) systems
  • ONTAP 9
  • disk shelf

Issue

SAS host adapter shows a PHY with status disabled:

	slot 2: SAS Host Adapter 2b (PMC-Sierra PM8072 rev. C, SAS, <UP>)
		Firmware rev:       03.08.09.00
		Base WWN:           xxxxxxxxxxxxxxx
		Phy State:          [8] Enabled, 6.0 Gb/s
		                    [9] Enabled, 6.0 Gb/s
		                    [10] Enabled, 6.0 Gb/s
		                    [11] Disabled
		QSFP Vendor:        Molex Inc.      
		QSFP Part Number:   112-00242+B0    
		QSFP Type:          Active Copper (near and far end limiting active equalizers) 10m ID:01
		QSFP Serial Number: xxxxxxxxxxxxxxx
 
Messages similar to the below may be reported by the storage:
System Notification (Health Monitor process nchm: DegradedOnlinePort_Alert[2b]) ALERT

 

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.

 

  • Was this article helpful?