Skip to main content
NetApp Knowledge Base

CN1610 Switch reboots with "Switch was reset due to power disruption" error

Views:
392
Visibility:
Public
Votes:
0
Category:
fas-systems
Specialty:
hw
Last Updated:

Applies to

CN1610 Cluster network switch

Issue

CN1610 Switch reboot with the following error.

Example:

<9> Jun 20 02:06:01 0.0.0.0-1 SIM[Cnfgr_Thread ]: sim_util.c(3804) 3 %% Switch was reset due to power disruption.
<10> Jun 20 02:06:01 0.0.0.0-1 General[fp_main_task]: bootos.c(195) 2 %% Event(0xaaaaaaaa)
<13> Jun 20 02:06:01 0.0.0.0-1 BSP[fp_main_task]: bootos.c(179) 1 %% BSP initialization complete, starting switch firmware.

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.

 

  • Was this article helpful?