Skip to main content
NetApp Knowledge Base

'vserver fcp topology show' command output incomplete

Views:
167
Visibility:
Public
Votes:
0
Category:
ontap-9
Specialty:
san
Last Updated:

Applies to

  • ONTAP 9
  • FCP

Issue

'vserver fcp topology show' command output is incomplete and does not contain all the logical interfaces

::> net int show -vserver vserver_1
  (network interface show)
            Logical    Status     Network Current       Current Is
Vserver     Interface  Admin/Oper Address/Mask       Node          Port    Home
----------- ---------- ---------- ------------------ ------------- ------- ----
vserver_1
            node_1_fc_lif_1 up/up 20:00:00:a0:xx:xx:xx:xx node_1     0e true
            node_1_fc_lif_2 up/up 20:01:00:a0:xx:xx:xx:xx node_1     0f true
            node_2_fc_lif_1 up/up 20:02:00:a0:xx:xx:xx:xx node_2     0e true
            node_2_fc_lif_2 up/up 20:03:00:a0:xx:xx:xx:xx node_2     0f true

In the example below, only 3 entries are shown instead of 4 (for each LIF):
:*> vserver fcp topology show
                       Domain Logical                                     Port
Vserver LIF Name       Id     Name   WWN                     Count
------- -------------- ------ ------------------- ----------------------- -----
vserver_1 
        node_1_fc_lif_1  1      switch1          10:00:c4:f5:7c:xx:xx:xx  24
                               
         node_1_fc_lif_2  1     switch2          10:00:c4:f5:7c:xx:xx:xx  24
                       
         node_2_fc_lif_1  1     switch1          10:00:c4:f5:7c:xx:xx:xx  24
                       
3 entries were displayed.

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

Scan to view the article on your device