Skip to main content
NetApp Knowledge Base

"storage failover hwassist show" results in No valid port/IP address config received

Views:
347
Visibility:
Public
Votes:
0
Category:
fas-systems
Specialty:
hw
Last Updated:

Applies to

  • AFF A700s
  • AFF A400
  • FAS 8300
  • ONTAP 9

Issue

  • After running cluster setup, when issuing the "storage failover hwassist show" command, the following error is displayed:
::cluster*> storage failover show -fields hwassist,hwassist-partner-port,hwassist-retry-count,hwassist-partner-ip,hwassist-health-check-interval,hwassist-status
node hwassist hwassist-partner-ip hwassist-partner-port hwassist-health-check-interval hwassist-retry-count hwassist-status
------------ -------- ------------------- --------------------- ------------------------------ -------------------- --------------------------------------------------
pemnacl01-01 true     192.0.2.85          162
180                            2                    inactive:No valid port/IP address config received.
pemnacl01-02 true   192.0.2.84          162                   180                            2

 

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

Scan to view the article on your device