Skip to main content
NetApp Knowledge Base

What is the default IP behavior when configuring management ports on E-Series?

Views:
1,301
Visibility:
Public
Votes:
0
Category:
e-series-systems
Specialty:
esg
Last Updated:

 

Applies to

All E-Series platforms

Answer

E-Series default management port IP behavior:

  • E-Series controllers ship with DHCP enabled by default. If a controller is unable to obtain a DHCP address on a given network port, it will revert to a default static IP address. This process can take up to 3 minutes.
  • Default static IP addresses are not persisted across link-down events when a network port on a controller is set to use DHCP.
    • If a port is configured for DHCP the controller will attempt to obtain a DHCP address on every link-up event, including cable insertions, reboots, and power cycles. 
    • Any time a DHCP attempt fails, the default static IP address for that port will be used. 
  • When using DHCP, the recommendation is to use a permanent DHCP lease.
  • When using static IP addresses it is recommended to set a static IP using SANtricity. Once a static IP is configured, it will persist through all link down/up events.
  • NOTE:
    • After changing the management IP address, the SANtricity management software might be unable to connect to the storage array.
    • Remove the storage array from the Enterprise Management window and then add it again.

Additional information about the default management port IP addresses can be found on this article.

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.