Skip to main content
NetApp Knowledge Base

E-Series Asynchronous remote volume mirroring "ARVM" setup encounters error that data could not be loaded from the storage array

Views:
292
Visibility:
Public
Votes:
0
Category:
e-series-systems
Specialty:
esg
Last Updated:

Applies to

  • E-Series Platforms: E28X0 and E57X0
  • E-Series CFW: 08.40.x and above

Issue

When attempting to Create Mirrored pair or Consistency Group, an error is received before any further setup.

Error
Data could not be loaded from the storage array.  One possible cause is the object on which you you were performing the operation no longer exists.  Other possible causes include network issues, inability to communicate with the controller, or loss of power to the storage array.  Check these causes and then retry the operation.
  

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.