Skip to main content
NetApp Knowledge Base

Discrete lines diagnostic failure

  1. Last updated
  2. Save as PDF
Views:
747
Visibility:
Public
Votes:
0
Category:
e-series-systems
Specialty:
esg
Last Updated:

 

Applies to

  • ESG
  • Controller: Any type can be applicable
  • Firmware Version: Any version pre-LSIP200662533 (not yet fixed) is applicable
  • This issue is fixed in CFW 8.20.20.xx+ and 8.25.07.xx+.

Issue

Discrete line diagnostic failure event observed in the MEL.
The MEL event 'Discrete lines diagnostic failure' is reported against both controllers, and is then resolved on both within 13 seconds.

 

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.