Skip to main content
NetApp Knowledge Base

Can not change the shelf ID for newly added DS224C shelves with IOM12B

  1. Last updated
  2. Save as PDF
Views:
370
Visibility:
Public
Votes:
0
Category:
e-series-disk-shelves
Specialty:
esg
Last Updated:

Applies to

  • E2800
  • DS224C shelf with IOM12B
  • SANtricity 11.70.1 and earlier

Issue

  • Can not change the shelf ID with the below error:
The operation cannot complete because of an incorrect parameter in the command sent to the controller.
Please retry the operation. If this message persists, contact your Technical Support Representative. (API 4)
  • E-Series system manager can not show the newly added DS224C shelf with IOM12B.

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.