Skip to main content
NetApp Knowledge Base

E-Series after drive replacement it still reports pool preservation capacity in use

Views:
1,333
Visibility:
Public
Votes:
1
Category:
e-series-systems
Specialty:
esg
Last Updated:

Applies to

  • E-Series SANtricity OS 11.50.1
  • NetApp StorageGRID 11.3.x
  • Controller Firmware Version 08.51.00.00
  • Disk Type HUH721008AL5204  Firmware NE01

Issue

  • After Drive failure and replacement the system continues to report a critical event
    • Failure Entry 1: DISK_POOL_RECONSTRUCTION_DRIVE_COUNT_BELOW_THRESHOLD-Recovery Failure Type Code: 424
  • Investigation does not reveal any failed drives in the disk pool

 

 

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.