Skip to main content
NetApp Knowledge Base

sysconfig -r shows spare disk in Awaiting savecore state

Views:
925
Visibility:
Public
Votes:
0
Category:
data-ontap-7
Specialty:
7dot
Last Updated:

Applies to

  • Data ONTAP 7-mode

Issue

Spare disk is in Awaiting savecore state in sysconfig -r output.

Example:

sysconfig -r

RAID Disk  Device  HA SHELF BAY   CHAN Pool Type RPM   Used (MB/blks)   Phys (MB/blks)
---------  ------  -------------  ---- ---- ---- ----- --------------   --------------
Spare disks for block or zoned checksum traditional volumes or aggregates
spare      0x.xx   0a 2     13    FC:A -    FCAL 10000 136000/278528000 137422/281442144 (Awaiting savecore)
spare      0yy.yy  0a 3     13    FC:A -    FCAL 10000 136000/278528000 137422/281442144

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.