Skip to main content
NetApp Knowledge Base

Unable to run "cf: forcetakeover -d" since remote synchronous mirroring is not enabled

Views:
54
Visibility:
Public
Votes:
0
Category:
data-ontap-8
Specialty:
7dot
Last Updated:

Applies to

  • Metrocluster
  • Data ONTAP 7-mode

Issue

After running the cf forcetakeover -d command during a disaster or site failover test, the following error message is displayed:

'cf: forcetakeover -d cannot be performed because remote synchronous mirroring is not enabled'

However all aggregates show as "mirrored" in aggr status output.

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

Scan to view the article on your device