Skip to main content
NetApp Knowledge Base

Snapvault snapshots on source volume are not being rolled off as per the retention in 7 mode

Views:
238
Visibility:
Public
Votes:
0
Category:
not set
Specialty:
7dot
Last Updated:

Applies to

  • Data ONTAP 8.2 - 7 mode and earlier
  • SnapMirror
  • SnapVault

Issue

SnapVault snapshots on source volume are not being rolled off as per the retention

A Snapvault to Snapmirror cascade can be depicted as below:
(Volume A)  ------------------> (Volume B) --------------------> (Snapmirror to TAPE)

Snapvault Source             Snapvault destination         Snapmirror destination

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.