Skip to main content
NetApp Knowledge Base

What is the autosupport.support.proxy option in Data ONTAP 7-mode?

Views:
731
Visibility:
Public
Votes:
0
Category:
data-ontap-7
Specialty:
7dot
Last Updated:

Applies to

  • Data ONTAP 7
  • Data ONTAP 8 7-mode
  • AutoSupport

Answer

Run the  >options autosupport command to view your current configuration

  • The autosupport.support.proxy option allows the setting of an HTTP-based proxy if autosupport.support.transport is HTTPS or HTTP.
  • The default for this option is the empty string, implying no proxy is necessary.
  • Both IPv6 and IPv4 addresses are accepted.
You use this option to specify user name and password for proxy authentication. The URL is entered without an http:// or https:// prefix. The following are some examples:
  • options autosupport.support.proxy myusername:mypassword@myhost.com
  • options autosupport.support.proxy myusername:mypassword@myhost.com:9090
  • options autosupport.support.proxy myhost.com
  • options autosupport.support.proxy myhost.com:9090
 
Note: Proxy configuration defaults to port 3128 when no port is specified.
  • There are many possible combinations that can be used, including HTTP arguments and CGI invocations. Contact your IT department for the correct HTTP proxy syntax.
NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.