Skip to main content
NetApp Knowledge Base

Upgrade to clustered Data ONTAP 8.3 fails on new setup

Views:
230
Visibility:
Public
Votes:
0
Category:
data-ontap-8
Specialty:
core
Last Updated:

Applies to

  • Data ONTAP 8.3

Issue

If the upgrade to clustered Data ONTAP 8.3 fails on new setup with the following error:


********************************************************************************
* This filer contains FreeBSD configured ports.
* You must correct this failure to avoid service disruptions.
*
* The following corrective action is required:
* Set the -privilege level do diagnostic:
* set -privilege diagnostic
* Issue the following commands:
* systemshell -node <node> 'kenv -upq bootarg.activatebsdport'
* systemshell -node <node> 'kenv -upq bootarg.activatebsdport.persist'
* systemshell -node <node> 'kenv -upq bootarg.givebsdmgmtport'
*******************************
*************************************************
Retry the image installation after taking corrective action.
ERROR: LIF sufficiency check failed.
Install Failed.
Install Validation Failed. ERROR: LIF sufficiency check failed.
Error: command failed: Install Failed. Install Validation Failed. ERROR: LIF sufficiency check failed.

 

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

Scan to view the article on your device