Skip to main content
NetApp Knowledge Base

Unable to delete VLAN and ifgrp configuration from node during controller replace

Views:
509
Visibility:
Public
Votes:
0
Category:
ontap-9
Specialty:
nas
Last Updated:

Applies to

ONTAP 9
AFF-A300

Issue

  • While performing a system controller replace operation to replace Node01 (AFF-A300) in a 2-node cluster with a new AFF-A400 controller the customer was unable to remove the VLAN and interface group (ifgrp) configuration on Node01.  This caused the operation to pause and it was not able to be resumed:

Example:

::*> system controller replace resume

Error: VLAN present on node . Remove and resume again.
       command failed: Operation is not in proper state to resume.

  • When the customer attempted to remove the VLAN configuration the command failed with this error:

Example:

Error: command failed: Cannot remove port that is a failover target for a LIF. To list LIFs containing a failover target, use the "network interface show -failover-targets <targetname>" command.

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.