Single mode Ifgrp port becomes unresponsive after active member port gets down/up
Applies to
ONTAP 9.2 and later
Issue
In ONTAP 9.2 and later, following issues are observed when using single-mode ifgrp.
- Link-down on a member port of a single-mode Ifgrp, or the cable gets disconnected from an active port.
- Standby port is switched over to the active state immediately, and client access is continued.
- After the link-down issue is fixed, the primary port goes back to active state.
- Ifgrp port becomes unresponsive, Clients access lost to storage.