Skip to main content
NetApp Knowledge Base

ONTAP Service Processor output "Error: command failed: Database is not open."

Views:
1,192
Visibility:
Public
Votes:
0
Category:
fas-systems
Specialty:
hw
Last Updated:

Applies to

  • FAS8200
  • ONTAP version: 9.5P13
  • Service Processor (SP) version: 5.6P2

Issue

  • Controller replacement running SP fw. version 5.6P2.
  • No SSH to the SP of that node
  • SP status on that node not visible in the ONTAP command line interface (CLI). Example:

::> system service-processor show
 IP Firmware
Node          Type Status      Configured   Version   IP Address
------------- ---- ----------- ------------ --------- -------------------------
Node_name1    SP   online      true         5.6P2     xxx.yyy.zzz.ttt

Error: show failed: Database is not open.

 
 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.