Skip to main content
NetApp Knowledge Base

ONTAP 9: Some interfaces not showing when scanning via SNMP

Views:
153
Visibility:
Public
Votes:
0
Category:
ontap-9
Specialty:
core
Last Updated:

Applies to

ONTAP 9

Issue

When querying the cluster via SNMP walk it is possible not to get all the network interfaces on the outputs.

This can be further confirmed by running the cluster command. network port show where we would be able to see the missing interfaces.

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.
  • Was this article helpful?