Skip to main content
NetApp Knowledge Base

How to run sysconfig -a or sysconfig -r in ONTAP 9

  1. Last updated
  2. Save as PDF
Views:
15,006
Visibility:
Public
Votes:
12
Category:
ontap-9
Specialty:
core
Last Updated:

​

​

Applies to

ONTAP 9

Description

To run sysconfig -a or sysconfig -r in ONTAP 9 you must interact with the node shell.

  • sysconfig -a output will display hardware-specific information for the node you are currently on.

Examples of information from this command are:

  • System ID & Partner ID (if in HA)
  • Hardware configurations
  • Firmware versions
  • Serial number information for disks, motherboards, and other hardware components

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.

 

  1. Back to top
  • Was this article helpful?

Recommended articles

  1. Article type
    How-to
    Confidence
    Validated
    Flag
    False
    Governance
    Experience
    KCS Enabled
    Yes
    Visibility
    Public
    Product Categories
    ONTAP 9
    Specialty
    Core
  2. Tags
    1. 1030605
    2. Elio
    3. KBTV
    4. type:howto