Skip to main content
NetApp Knowledge Base

How to run ndmpcopy in ONTAP

Views:
11,334
Visibility:
Public
Votes:
8
Category:
ontap-9
Specialty:
dp
Last Updated:

Applies to

ONTAP 9

Description

  • This article describes how to run ndmpcopy
  • The ndmpcopy command is run from the cluster shell, via node run 
  • Ndmpcopy can be run from the command line of either the source or destination storage system to transfer data between two systems
  • Ndmpcopy can also be run on a single storage system, transferring data from one location to another within the same storage system
  • To take advantage of the NDMP Cluster Aware Backup (CAB) extension, all storage systems involved in the ndmpcopy must be in vserver-scoped mode
    • This includes the storage system on which the ndmpcopy command is being run.

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.