Skip to main content
NetApp Knowledge Base

How to make major changes to vif configuration with minimal impact to system availability

  1. Last updated
  2. Save as PDF
Views:
541
Visibility:
Public
Votes:
0
Category:
data-ontap-7
Specialty:
7dot
Last Updated:

​

​

Applies to

Data ONTAP 7

Description

  • Configure a Virtual Interface (vif) to span two multi-mode vifs with a single-mode vif.
  • The IP addresses need to remain the same when the configuration is updated.
  • The update should not cause a network service interruption.

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.