EMS log show "cf_hwassist: cf.hwassist.IpNotConfigured" error message
Applies to
- FAS 8200
- ONTAP 9.5P12
Issue
- EMS log show below message :
[cf_hwassist: cf.hwassist.IpNotConfigured:error]: cf hw_assist: Partner(node name)'s SP is not configured with the right IP address family. Use the "storage failover hwassist show" command for details.
- Use the "
storage failover hwassist show
" command to check:
::> storage failover hwassist show
Node
-------------------------
Node01
Partner: Node02
Hwassist Enabled: true
Hwassist IP: 2405:aaaa:bbb1:cccc:01
Hwassist Port: 4444
Monitor Status: inactive
Inactive Reason: SP on Node02 is not configured with IPv6 address.
Corrective Action: Configure a valid IPv6 address for SP on Node02
Keep-Alive Status: -
Node02
Partner: Node01
Hwassist Enabled: true
Hwassist IP: 2405:aaaa:bbb2:cccc:02
Hwassist Port: 4444
Monitor Status: active
Inactive Reason: -
Corrective Action: -
Keep-Alive Status: healthy
2 entries were displayed.
- Node02 's IPv6 address is configured from
SYSCONFIG-A
of AutoSupport
Service Processor Status: Online
Firmware Version: 5.10
Mgmt MAC Address: 00:AA:99:EE:FF:DD
Ethernet Link: up, full duplex, auto-neg complete
Using DHCP: no
IPv4 configuration:
IP Address: 22.xx.x.xxx
Netmask: 255.255.255.0
Gateway: 22.xx.x.xxx
IPv6 configuration:
Global IP: 2405:aaaa:bbb1:cccc:1a
Prefix Length: 64
Gateway: 2405:aaaa:bbb1:cccc:1
Link Local IP: fe80::aaa:ffff:eeee:dddd
Prefix Length: 64
[Service Processor cached network information determined at Mon Apr 18 19:32:55 CST 2022]