Skip to main content
NetApp Knowledge Base

Automatic disk assignment fails for replaced disk in ONTAP

Views:
763
Visibility:
Public
Votes:
1
Category:
ontap-9
Specialty:
hw
Last Updated:

Applies to

ONTAP 9

Issue

When a replacement disk is inserted into an ONTAP 9 system, the disk might not automatically get assigned.  The following messages might be observed:

10/30/2020 11:36:28 NODE1 ERROR diskown.AutoAssign.MultipleOwners: Automatic assigning failed for disk 0b.06.19 (S/N XXXXXXXX) because the disks on the loop are owned by multiple systems. Automatic assigning failed for all unowned disks on this loop.

10/30/2020 11:36:28 NODE1   ERROR         diskown.AutoAssign.MultipleOwners: Automatic assigning failed for disk 0b.06.19 (S/N XXXXXX) because the disks on the loop are owned by multiple systems. Automatic assigning failed for all unowned disks on this loop.

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.