Skip to main content
NetApp Knowledge Base

Automatic assigning failed for disk in ONTAP after cluster setup

Views:
540
Visibility:
Public
Votes:
0
Category:
ontap-9
Specialty:
core
Last Updated:

Applies to

  • ONTAP 9
  • New Cluster setup

Issue

  • Disks may fail to autoassign when disks on the same loop are owned by multiple systems. 

10/30/2020 11:36:28 NODE1 ERROR diskown.AutoAssign.MultipleOwners: Automatic assigning failed for disk 0b.06.19 (S/N XXXXXXXX) because the disks on the loop are owned by multiple systems. Automatic assigning failed for all unowned disks on this loop.

  • Additional event logs show the following errors denoting autoassign can’t run.

10/30/2020 11:36:28 NODE1   ERROR         diskown.AutoAssign.MultipleOwners: Automatic assigning failed for disk 0b.06.19 (S/N XXXXXX) because the disks on the loop are owned by multiple systems. Automatic assigning failed for all unowned disks on this loop.

 

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

Scan to view the article on your device

 

  • Was this article helpful?