Skip to main content
NetApp Knowledge Base

Adaptive QoS maximum latency for volume when IO is below its expected IO limit

Views:
314
Visibility:
Public
Votes:
0
Category:
ontap-9
Specialty:
perf
Last Updated:

Applies to

  • ONTAP 9
  • Adaptive QoS (AQoS)

Issue

  • AQoS maximum latency seen when workload IO is less then configured maximum
  • Volumes in the cluster show a problem where AQoS should be granting more IO than it apparently is
  • Clients report filesysem mounting failures on NetApp volume (even for smaller volumes) associated with high latency reported from QOS limit  

2009707776 - High Latency and limit fixed.png 

2009707776 - QOS Limit.png

2009707776 - Vol size.png

 

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.