Coming soon...New Support-Specific categorization of Knowledge Articles in the NetApp Knowledge Base site to improve navigation, searchability and your self-service journey.

Home
Advice and Troubleshooting
Data Storage Software
ONTAP OS
'Mapping Ports' step during headswap fails with "Error: Cannot run this command because the system is not fully initialized."

'Mapping Ports' step during headswap fails with "Error: Cannot run this command because the system is not fully initialized."

Last updated
Save as PDF
Share
1. Share
2. Tweet
3. Share

Views:: 1,235

Visibility:: Public

Votes:: 1

Category:: aff-series

Specialty:: hw

Last Updated:

Applies to

ONTAP 9

Issue

During the 'Mapping Ports' step in the headswap guide, commands fail with Error: Cannot run this command because the system is not fully initialized. Wait a few minutes, and then try the command again.
RDB applications will also show offline during this step. This can be verified with the diagnostic command cluster ring show