Skip to main content
NetApp Knowledge Base

"Event Log Show" output does not show all events by default

Views:
764
Visibility:
Public
Votes:
2
Category:
ontap-9
Specialty:
core
Last Updated:

Applies to

ONTAP 9

Issue

While using the event log show command in ONTAP, only a subset of events are shown.

cluster1::> event log show
Time                Node             Severity      Event
------------------- ---------------- ------------- ---------------------------
1/11/2022 18:16:27  cluster1-01      ERROR         configbr.noDestURL: Cluster backup is saved on only one node and no offsite configuration backup destination URL is configured.
1/10/2022 22:02:33  cluster1-01      ERROR         Nblade.nfsConnResetAndClose: Shutting down connection with the client. Vserver ID is 2; network data protocol is port map, Rpc Xid 0x0; client IP address:port is 10.20.20.20:462. local IP address is 10.10.10.10; reason is OncRpcTcpInvalidRecordMarker.

 

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.