"Chassis Power Fault detected" messages in ConfigAdvisor

Last updated
Save as PDF
Share
1. Share
2. Tweet
3. Share

Views:: 84

Visibility:: Public

Votes:: 0

Category:: ontap-9

Specialty:: hw

Last Updated:

Applies to

FAS8300 / FAS8700 / AFF A400
1600W PSU
All ONTAP versions
BMC firmware 13.6 or lower
ActiveIQ ConfigAdvisor

Issue

ActiveIQ ConfigAdvisor reports an alert of Chassis Power Fault detected with further details of Chassis power supply 2 and 1 have failed, been removed, or turned-off
System is up and running and no PSU failure is noticed upon physical inspection
system node environment sensors show -name PSU* will only display sensors PSU1 Vin Type and PSU2 Vin Type as failed

cluster::> system node environment sensors show -name PSU* Node Sensor State Value/Units Crit-Low Warn-Low Warn-Hi Crit-Hi ---- --------------------- ------ ----------- -------- -------- ------- ------- node01 PSU1 VIN failed PSU1 VOUT normal 12012 mV 11336 11440 12948 13156 PSU1 Curr IIN normal 832 mA 0 - 9984 12012 PSU1 IOUT normal 12000 mA 0 - 130000 132000 PSU1 PIN normal 170400 mW 7100 14200 1611700 1796300 PSU1 POUT normal 149100 mW 7100 14200 1611700 1796300 PSU1 Inlet normal 22 C 0 - 58 63 PSU1 Hot normal 32 C 0 - 100 105 PSU1 FB Hot normal 29 C 0 - 100 105 PSU1 FAN normal 4500 RPM 800 1200 - - PSU2 VIN failed PSU2 VOUT normal 12012 mV 11336 11440 12948 13156 PSU2 Curr IIN normal 988 mA 0 - 9984 12012 PSU2 IOUT normal 15000 mA 0 - 130000 132000 PSU2 PIN normal 198800 mW 7100 14200 1611700 1796300 PSU2 POUT normal 177500 mW 7100 14200 1611700 1796300 PSU2 Inlet normal 24 C 0 - 58 63 PSU2 Hot normal 33 C 0 - 100 105 PSU2 FB Hot normal 30 C 0 - 100 105 PSU2 FAN normal 4500 RPM 800 1200 - - PSU1 Present normal PRESENT PSU2 Present normal PRESENT PSU1 normal GOOD PSU2 normal GOOD