Skip to main content
NetApp Knowledge Base

irqBalanceFailed errors after networkConfig interface alerts

Views:
228
Visibility:
Public
Votes:
0
Category:
element-software
Specialty:
solidfire
Last Updated:

Applies to

NetApp Element Software

Issue

  1. networkConfig - Network interface ethX is down or cable is unplugged. alert gets generated at NetApp SolidFire Active IQ
  2. If LACP is being utilized for the regarding interface incorrectBondPortCount - Incorrect bond port counts detected on the Bond10G interfaces of nodes: {NodeID} alert will get populated
  3. A while after those alerts, irqBalanceFailed - Failed to balance interrupts. Performance may be degraded. Error(s): {  Expected interrupts not found for ethX,..} alert gets generated as well

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.