Skip to main content
NetApp Knowledge Base

No failover for ActivePassive bonding on Element storage nodes with Mellanox NIC

  1. Last updated
  2. Save as PDF
Views:
267
Visibility:
Public
Votes:
0
Category:
element-software
Specialty:
hci
Last Updated:

Applies to

  • NetApp H-series
    • NetApp HCI H410S
    • NetApp HCI H300S
    • NetApp HCI H500S 
    • NetApp HCI H700S 
    • NetApp HCI H610S
  • Mellanox NIC FW version 14.22.1002
  • NetApp Element 11.3 - 12.0 (affected FW version is embedded in listed Element releases)
  • HCI 1.6 or beyond
  • ActivePassive bonding on 10G

Issue

  • When the active network interface goes down, there is no failover to the secondary interface
  • In case of switch outage, this will result in all volumes going offline

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.