Skip to main content
We are redesigning the NetApp Knowledge Base site to make it easier to use and navigate. The new and improved site will be available the first week of October. Check out our video or read this KB article to know more about changes you’ll see on the site.
NetApp Knowledge Base

Is it possible to change the MTU post install on NetApp HCI Systems

Views:
174
Visibility:
Public
Votes:
0
Category:
element-software
Specialty:
hci
Last Updated:

Applies to

  • NetApp HCI
  • NetApp Deployment Engine (NDE)
  • Maximum Transmission Unit (MTU)

Answer

The MTU size setting on all HCI nodes can be changed to the default 1500 value after NetApp Deployment Engine (NDE) has completed deploying the system, however, it is not supported by NDE itself.

If the MTU size setting were to be changed to 1500, NDE's EasyScale utility would not be able to add new compute or storage nodes to existing VMware ESXi or NetApp Element Software clusters.

Additional Information

additionalInformation_text

 

 

******************************************************* *******************************************************