Skip to main content
NetApp Knowledge Base

SnapMirror protect command does not  work for type DP volumes

Views:
619
Visibility:
Public
Votes:
0
Category:
snapmirror
Specialty:
dp
Last Updated:

Applies to

  • ONTAP 9
  • SnapMirror

Issue

  • snapmirror protect command for a volume of type DP creates a job but the job will fail with error:
    • "Snapmirror protect of source volume <volume> (DP) failed to destination vserver <vserver> because the source volume was not found."

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.