Skip to main content
NetApp Knowledge Base

SnapMirror command for Flexgroup Volume fails with "Relationship information has been updated and is being propagated"

Views:
799
Visibility:
Public
Votes:
0
Category:
snapmirror
Specialty:
dp
Last Updated:

Applies to

  • SnapMirror
  • FlexGroup
  • ONTAP 9.x
  • Persistent failure of SnapMirror commands with:

Relationship information has been updated and is being propagated. Wait a few minutes and try the command again

Issue

  • On a  SnapMirror destination, SnapMirror commands run against a FlexGroup volume fail with the error:

Relationship information has been updated and is being propagated. Wait a few minutes and try the command again.

  • SnapMirror commands persistently fail with the same message, even after waiting a few minutes (or longer period of time)

Note: If, after receiving the above error, later attempts to run SnapMirror commands succeed, the cause and solution in this KB does not apply

  • The SnapMirror destination Sktrace log contains:

SM_HIGH_4: [sm_rpl_admin_cg_mgmt.c:4077]: Cache: resume CG[<vol_name>] : failed - CG not present in cache. = 0

Note: AutoSupport sktrace section may not contain the above message.  A manual collection of all sktrace logs, and search of the collected logs, is recommended

 

CUSTOMER EXCLUSIVE CONTENT

Registered NetApp customers get unlimited access to our dynamic Knowledge Base.

New authoritative content is published and updated each day by our team of experts.

Current Customer or Partner?

Sign In for unlimited access

New to NetApp?

Learn more about our award-winning Support

 

******************************************************* *******************************************************