Skip to main content
NetApp Knowledge Base

Is it possible to enable destination SVM within SVM DR for read-only access to data?

  1. Last updated
  2. Save as PDF
Views:
386
Visibility:
Public
Votes:
0
Category:
snapmirror
Specialty:
dp
Last Updated:

Applies to

  • ONTAP 9
  • SVM DR

Answer

Yes. When the -identity-preserve option is set to false, the volumes in destination SVM can be used for read-only access by starting SVM after the initial transfer is complete.

::> vserver start -vserver <DESTINATION_SVM>

Note: Data access needs to be configured on the destination volumes

Note: Source and destination SVM cannot run at the same time when the -identity-preserve option is set to true

Additional Information

 

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.