Skip to main content
NetApp Knowledge Base

After an upgrade to the SnapCenter 4.3.2 HANA Plug-in, the discovery fails with system replication not supported with auto-discovery

  1. Last updated
  2. Save as PDF
Views:
471
Visibility:
Public
Votes:
2
Category:
snapcenter
Specialty:
snapx
Last Updated:

Applies to

  • SnapCenter Plug-in for SAP HANA (SCHANA) 4.3.2 to 4.5P2

Issue

After the SCHANA plug-in upgrade to version 4.3.2, the plug-in runs discovery, which fails with the following message:

SCC-00155 Auto Discovery for plug-in [hana] failed with error [
Auto discovery is not supported for HANA instances with system replication configuration.
You must manually add this instance to SnapCenter Server.] end exist code [-1]. Exiting.

In contrast, the previous SCHANA version with automatic discovery (4.3.1Px), did not run into this error.

The effect of the error is, that a previously auto-discovered HANA resource (with SnapCenter 4.3 to 4.3.1P2) will be shown as "(Deleted/Renamed)" and can no longer be properly managed in the GUI, except by Resource Group, if it was already setup that way.

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.