Skip to main content
NetApp Knowledge Base

'VMware Tools OVF network configuration not found' occurs after deploying SCV OVA

  1. Last updated
  2. Save as PDF
Views:
484
Visibility:
Public
Votes:
4
Category:
snapcenter
Specialty:
SNAPX
Last Updated:

Applies to

SnapCenter Plug-in for VMware vSphere (SCV) 4.3 or later

Issue

  • After deploying SCV OVA, setting the network fails with the following error.

Booting SnapCenter Plug-in for VMware vSphere virtual application... Please
wait...

VMware Tools Check
Checking VMware Tools Install ...
VMWare Tools appears OK

NETWORK CONFIGURATION

Checking network link status. Please wait...
Link has been detected

Retrieving network configuration from VMware Tools. Please wait...
VMware Tools OVF network configuration not found.

Would you like to correct the configuration? [y]:

  • The same error occurs after rebooting SCV OVA.
  • The same error occurs after deploying another SCV OVA.

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.