No ports found on a MetroCluster DR node connected to fabric with fabric name xx:xx:xx:xx:xx:xx:xx:xx
Applies to
- Data ONTAP 9
- MetroCluster
- Cisco SAN switches
- Brocade SAN switches
Issue
After running the command:metrocluster check run
the output of:metrocluster check show
displays LIF warnings:
::> metrocluster check run
::> metrocluster check show
Last Checked On: dd/mm/yyyy hh:mm:ss
Component Result
------------------- ---------
nodes ok
lifs warning
config-replication ok
aggregates ok
clusters ok
Further analysis of the command:metrocluster check lif show
displays the following:
::> metrocluster check lif show
Vserver LIF Protocol Failure
-------------- --------- --------- ---------- ---------------
Vserver1 FCP01 fcp There are no ports on node "Node1" connected to fabric "xx:xx:xx:xx:xx:xx:xx:xx" in the destination cluster. Cannot place FC LIF "FCP01" hosted on the source cluster port "0e" of "CNA" adapter type for Vserver "Vserver1-mc".
Vserver1 FCP02 fcp There are no ports on node "Node1" connected to fabric "xx:xx:xx:xx:xx:xx:xx:xx" in the destination cluster. Cannot place FC LIF "FCP02" hosted on the source cluster port "0h" of "CNA" adapter type for Vserver "Vserver-mc".
Vserver2 FCP03 fcp No ports found on MetroCluster DR node "Node2" connected to fabric with fabric name "xx:xx:xx:xx:xx:xx:xx:xx"
Vserver2 FCP04 fcp No ports found on MetroCluster DR node "Node2" connected to fabric with fabric name "xx:xx:xx:xx:xx:xx:xx:xx"