Skip to main content
NetApp Knowledge Base

MetroCluster IP node does not boot after running set-defaults

Views:
267
Visibility:
Public
Votes:
0
Category:
metrocluster
Specialty:
metrocluster
Last Updated:

Applies to

  • MetroCluster IP
  • ONTAP 9
  • set-defaults run on a configured system
  • Motherboard replacement

Issue

After running set-defaults on a node that is already configured as part of a MetroCluster IP solution, the node fails to boot with the following messages reported during the boot attempt:

Attempting to use existing varfs on /dev/nvrd1
                                           <<<< Missing configuration for the MetroCluster IP interfaces
iw_cxgbe: Chelsio T5/T6 RDMA driver loaded.

Jun 30 08:07:51 [ClusterA-01:config.noPartnerDisks:error]: No disks were detected for the partner; this node cannot perform takeover correctly.

Waiting for requisite number of local mailboxes... (Press Ctrl-C to abort wait)

 

CUSTOMER EXCLUSIVE CONTENT

Registered NetApp customers get unlimited access to our dynamic Knowledge Base.

New authoritative content is published and updated each day by our team of experts.

Current Customer or Partner?

Sign In for unlimited access

New to NetApp?

Learn more about our award-winning Support