MetroCluster IP interfaces not connecting using a Cisco 3232 and a FAS 8200/AFF A300

Last updated
Save as PDF
Share
1. Share
2. Tweet
3. Share

Views:: 113

Visibility:: Public

Votes:: 0

Category:: metrocluster

Specialty:: metrocluster

Last Updated:

Applies to

MetroCluster IP
RCF applied
Switch not rebooted after applying the RCF file

Issue

After applying the RCF file the ports used to connect the AFF A300/FAS 8200 controller show the status Internal-Fail and status errDisable.

SWITCH01# show interface brief -------------------------------------------------------------------------------- Port VRF Status IP Address Speed MTU -------------------------------------------------------------------------------- mgmt0 -- up 10.10.10.10 1000 1500 -------------------------------------------------------------------------------- Ethernet VLAN Type Mode Status Reason Speed Por t Interface Ch # -------------------------------------------------------------------------------- Eth1/1 1 eth access down XCVR not inserted auto(D) -- .... Eth1/25/1 20 eth access down Internal-Fail errDisable auto(D) -- Eth1/25/2 20 eth access down Administratively down auto(D) -- Eth1/25/3 20 eth access down Administratively down auto(D) -- Eth1/25/4 20 eth access down Administratively down auto(D) -- Eth1/26/1 20 eth access down Internal-Fail errDisable auto(D) -- Eth1/26/2 20 eth access down Administratively down auto(D) -- Eth1/26/3 20 eth access down Administratively down auto(D) -- Eth1/26/4 20 eth access down Administratively down auto(D) -- Eth1/27/1 20 eth access down XCVR not inserted auto(D) --