MetroCluster Expert Recommended articles
Applies to
This article is a collection of commonly used Knowledgebase articles and Technical Reports utilized by NetApp Support:
Answer
- Types of MetroCluster:
How to identify different versions of MetroCluster
- DR Config Replication Failed:
DR CONFIG REPLICATION FAILED autosupport message
- Commands for Switchover, Healing and Switchback:
Switchover and Switchback
- ATTO FibreBridge In-band Management
How to change an ATTO FibreBridge to in-band management in 9.5 and later
- System Risks and Handling:
System Risk Overview
- SVM's offline after a Cluster Reboot:
MetroCluster Storage Virtual Machines stop after a cluster reboot or an unplanned power outage
- Site Verification (Fabric Attached Only):
How to determine which disks are local or remote to a filer in a Fabric MetroCluster Environment
- ATTO FibreBridge unexpected reboot:
How to collect log files from ATTO FibreBridge
Contact NetApp support for assistance once data is collected.
- SyncMirror Plex Fault:
AutoSupport message: SYNCMIRROR PLEX FAILED
- SyncMirror not rotating:
SyncMirror could not create resynchronization snapshot / SYNCMIRROR SNAPSHOTS NOT ROTATING
- LIF Placement
MetroCluster IP/iSCSI LIF is not using the expected interface on the partner cluster
Discovery of LIF with address (IP_Address) fails from the destination cluster
No ports found on a MetroCluster DR node connected to fabric with fabric name xx:xx:xx:xx:xx:xx:xx:xx
MetroCluster FCP LIF is not using the expected interface on the partner cluster
- MetroCluster Check
How to troubleshoot MetroCluster check LIF errors
How to troubleshoot MetroCluster check cluster errors
How to troubleshoot MetroCluster check node errors
How to troubleshoot MetroCluster check aggregate errors
How to troubleshoot MetroCluster check connection errors
How to troubleshoot MetroCluster check config replication errors
Additional Information