Skip to main content
NetApp Knowledge Base

MetroCluster-IP Switchback Fails With Error (fatal): Configuration replication service is not ready in cluster

  1. Last updated
  2. Save as PDF
Views:
323
Visibility:
Public
Votes:
0
Category:
metrocluster
Specialty:
metrocluster
Last Updated:

Applies to

  • MetroCluster-IP
  • ONTAP 9
  • In switchover state
  • All nodes booted

Issue

Switchback fails with error messages:

Failed to set up the node and cluster components for the switchback operation.  Cluster01 (fatal): Configuration

replication service is not ready in cluster "Cluster02". Wait a few minutes, then try the command again.

Cluster01::Cluster01-N1 (non-overridable veto): Failed to read DR partner state. Verify that the Fibre Channel
interconnect is up and not cross-connected, then retry the operation.

Search the EMS event log for multiple iterations of these error messages:

[Cluster01: DR_heartbeat_thread: cf.ic.xferTimedOutVSA:notice]: HA interconnect: MCC_DRSOM transfer timed out.
[Cluster01: DR_heartbeat_thread: ems.engine.suppressed:debug]: Event 'rdma.rlib.event.error' suppressed 6 times in last 60
seconds.

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.