How To change Health Monitoring from SNMPv1 to SNMPv3 on a Brocade switch?
Applies to
- MetroCluster
- Brocade
- HealthMonitor
Description
This procedure explains how to change the Health Monitoring for a Brocade switch in a MetroCluster backend from SNMPv1 to SNMPv3.
Procedure
Remove the switch from Health Monitoring
List all the switches that use SNMPv1.
ClusterA::> storage switch show -snmp-version !SNMPv3
Symbolic Is Monitor
Switch Name Vendor Model Switch WWN Monitored Status
--------------------- -------- ------- ----- ---------------- --------- -------
Brocade_10.10.10.1
switch1
Brocade Brocade6510
1000c4f57c46affe true ok
Brocade_10.10.10.2
switch2
Brocade Brocade6510
1000c4f57c46bffe true ok
2 entries were displayed.
Add the switch to Health Monitoring using SNMPv3
Add the switches to Health Monitoring using SNMPv3 following the instructions:
Configuring SNMPv3 in a MetroCluster configuration
Add the switch to monitoring using the following command:
ClusterA::> storage switch add -address 10.10.10.1 -snmp-community-or-username <snmpv3user> -snmp-version SNMPv3