Skip to main content
NetApp Knowledgebase

Does ATTO bridge request to restart/reboot after change management IP address ?

Views:
120
Visibility:
Public
Votes:
0
Category:
metrocluster
Specialty:
metrocluster
Last Updated:

Applies to

ATTO FibreBridge

Answer

Yes, after configure or modify ATTO management IP address, you must run the commands"SaveConfiguration" and you are prompted to restart the bridge to put the new configuration into effect.

To set the IP address without the QuickNAV utility, you need to have a serial connection to the FibreBridge.

Example
If using the CLI, you must run the following commands:

set ipaddress mp1 ip-address
set ipsubnetmask mp1 subnet-mask
set ipgateway mp1 x.x.x.x
set ipdhcp mp1 disabled
set ethernetspeed mp1 1000
SaveConfiguration

You are prompted to restart the bridge.

Additional Information