Skip to main content
NetApp Knowledge Base

Do we need to clear config and apply new RCF when updating switch firmware

Views:
113
Visibility:
Public
Votes:
0
Category:
metrocluster
Specialty:
metrocluster
Last Updated:

Applies to

  • Cisco 3232c
  • MetroCluster IP

Answer

No, erasing the Cisco switch configuration is only required when you want to reinstall the same RCF file after a previous installation failed, or if you want to install a new version of an RCF file.
NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.