Skip to main content
NetApp Knowledge Base

What is the procedure for a graceful shutdown & power up of an AVA during a scheduled power outage?

Views:
561
Visibility:
Public
Votes:
0
Category:
altavault
Specialty:
legacy
Last Updated:

Applies to

  • AltaVault

Answer

Perform the following steps to power off the AltaVault in preparation for a scheduled power outage:

  1. Shut down the AltaVault using the CLI/WebUI
    CLI:
       > enable
       # reload halt


    WebUI:
         AltaVault: Settings > Reboot/Shutdown
  2. Remove the power to the AltaVault head unit by disconnecting the power cables.  The appliance will automatically boot when power is reapplied, and this step will prevent the device from booting if the power cycles during the maintenance period.
  3. Remove power to each expansion shelf power supply using the rocker switch located above each power cable.

Perform the following steps to power on the AltaVault after a scheduled power outage:

  1. Reapply power to all expansion shelves and wait for 10 seconds.
  2. Reapply power to the AltaVault head unit. The system will start up automatically, and can take up to 30 minutes to boot.
  3. Log in to the AltaVault and verify the system is healthy.

Additional Information

additionalInformation_text

 

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.