Skip to main content
NetApp Knowledge Base

Active IQ Unified Manager fails to add ONTAP cluster due to a breach of max number of EMS notification destinations

Views:
2,181
Visibility:
Public
Votes:
4
Category:
active-iq-unified-manager
Specialty:
om
Last Updated:

Applies to

  • Active IQ Unified Manager 9.x
  • ONTAP 9

Issue

  • Attempts to add an ONTAP cluster data source in Active IQ Unified Manager from the Cluster Setup page fails.
  • Prompting the return of an error message:

Unable to add data source, which can be caused by reaching the max number of EMS notification destinations in the data source.

or

Unable to add cluster data source. This can occur if the clocks on the systems are not synchronized and the Active IQ Unified Manager HTTPS certificate start date is later than the date on the cluster, or if the cluster has reached the maximum number of EMS notification destinations.

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.