Skip to main content
NetApp Knowledge Base

Why is Unified Manager showing a status of 'Yes' in the Applicable to Cluster column for the EMS event(s) added, but is not receiving EMS notifications from a cluster?

Views:
338
Visibility:
Public
Votes:
0
Category:
active-iq-unified-manager
Specialty:
om
Last Updated:

Applies to

  • OnCommand Unified Manager (OCUM) 7.x - 9.5.x
  • Active IQ Unified Manager (AIQUM) 9.6.x+

Answer

  • Unified Manager will display a status of 'Yes' if at least one subscription has been successful with a cluster.
    • To verify all clusters have been successfully configured, execute clustershell commands on each cluster that is reported to not be sending events to verify that Unified Manager is listed as a syslog destination and that the event of interest is configured to be routed to the Unified Manager syslog destination.
  • EMS events are sent using the syslog protocol which uses port 514. Verify that port 514 is open to send UDP traffic to Unified Manager.
  • Verify the EMS event in question is applicable to the ONTAP release for a clusters monitored by Unified Manager by querying ONTAP for the event in question via clustershell commands. 

 

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.